Ignition Lock Cylinder Case

Ignition Lock Cylinder Case Replacement
Removal Procedure

1. Caution: Refer to Restraint Systems Caution in Service Precautions.

Disable the Restraint Systems. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
2. Remove the ignition switch.
3. Remove the turn signal cancel cam.
4. Remove the park lock cable from the lock cylinder housing.





5. Remove 3 TORX screws.
6. Remove the lock cylinder housing from the steering column.

Installation Procedure





1. Notice: Refer to Fastener in Service Precautions.

Install 3 TORX screws into the lock cylinder housing.
Tighten the TORX screws to 7 Nm (62 inch lbs.).
2. Install the turn signal cancel cam.
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch.
5. Enable the Restraint Systems. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.