Blower Motor Replacement

BLOWER MOTOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the right closeout/insulator panel.
2. Remove the I/P storage compartment door.







3. Disconnect the blower motor electrical connector.
4. Remove the blower motor mounting screws.
5. Remove the blower motor cooling tube.
6. Remove the blower motor (2).



INSTALLATION PROCEDURE







1. Install the blower motor (2).
2. Install the blower motor cooling tube.
3. Install the blower motor mounting screws.

NOTE: Refer to Fastener Notice in Service Precautions.


Tighten
Tighten the screws to 2 N.m (18 lb in).

4. Connect the blower motor electrical connector.
5. Install the right closeout/insulator panel.