Wiper Arm Replacement - Rear

WIPER ARM REPLACEMENT - REAR

REMOVAL PROCEDURE
1. Place the arm in the mid-wipe position on the rear glass.




2. Disconnect the washer hose (4).
3. Remove the wiper arm cover (2).
4. Disengage the nut (3) retaining the wiper arm to the pivot shaft.
5. Remove the wiper arm from the pivot shaft.
6. Remove the wiper arm blade from the wiper arm, if necessary.

INSTALLATION PROCEDURE
1. Park the rear wiper motor.
2. Install the wiper arm blade to the wiper arm, if removed.




3. Position the wiper arm into the park ramp.
4. Install the wiper arm onto the motor shaft with the nut (3). Hold the wiper arm into the park ramp while torquing the nut.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nut (3) to 20 N.m (15 lb ft).

5. Reposition the wiper arm cover (2).
6. Connect the washer hose (4).