Door Jamb Switch Replacement - Rear

DOOR JAMB SWITCH REPLACEMENT - REAR

REMOVAL PROCEDURE




1. Loosen the nut on the door jamb switch.
2. Gently pull the switch away from the body.
3. Disconnect the door jamb switch from the electrical connectors.
4. Tape the wiring to the body in order to prevent the wiring from entering the hole in the door pillar.
5. Remove the door jamb switch from the vehicle.

INSTALLATION PROCEDURE
1. Install the door jamb switch to the vehicle.




2. Connect the electrical connectors to the door jamb switch.
3. Tighten the nut on the door jamb switch.

NOTE: Refer to Fastener Notice in Service Precautions.


Tighten the door jamb switch nut to 3 Nm (27 lb in).