Steering Wheel

Steering Wheel Replacement

^ Tools Required
- J 1859-A Steering Wheel Puller

Removal Procedure





Caution: Refer to SIR Caution in Service Precautions.

1. Disable the Restraints system.
2. Remove the steering wheel inflator module.
3. Remove the horn plunger from the steering column by pressing inward to the stop and rotation the horn plunger 90 degrees.





4. Remove the steering wheel retaining nut.





Notice: When removing the steering wheel, use only the specified steering wheel puller. Do not hammer on the end of the steering column shaft. Hammering could loosen the plastic injections which maintain the steering column rigidity.

5. Install the J 1859-A to the steering wheel.
6. Remove the steering wheel using the J 1859-A.
7. Remove the J 1859-A from the steering wheel.

Installation Procedure
1. Install the steering wheel to the steering shaft.





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the steering wheel retaining nut.
^ Tighten the steering wheel retaining nut to 41 Nm (30 ft. lbs.).
3. Install the horn plunger to the steering column.
4. Install the steering wheel inflator module.
5. Enable the Restraints system.