Fog/Driving Lamp: Service and Repair

FOG LAMP REPLACEMENT - REAR

REMOVAL PROCEDURE
1. Disconnect the electrical connector from the lamp assembly.




2. Remove the nut retaining the lamp assembly to the bracket.




3. Remove the lamp assembly from the bumper.

INSTALLATION PROCEDURE




1. Install the lamp assembly to the bumper.




2. Install the nut to retain the lamp assembly to the bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nut to 2 N.m (18 in lb).

3. Install the electrical connector to the lamp assembly.