Oil Pump: Service and Repair

Oil Pump Replacement

Removal Procedure





1. Remove the oil pan.
2. Remove the oil pump bolt.
3. Remove the oil pump.





4. Inspect the oil pump locator pins for damage, and replace if required.
5. Clean and inspect the oil pump, if necessary.

Installation Procedure





1. Inspect for properly installed oil pump locator pins.






2. Install the oil pump. Position the oil pump onto the locator pins.

Important:
Do not reuse the oil pump driveshaft retainer. During assembly, install a NEW oil pump driveshaft retainer.


Notice: Refer to Fastener Notice in Service Precautions.

3. Install the oil pump bolt.
^ Tighten the bolt to 90 Nm (66 ft. lbs.).
4. Install the oil pan.