Energy Storage Box (ESB) 120V Cable Replacement

ENERGY STORAGE BOX (ESB) 120V CABLE REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the 120-volt AC electrical connector (3).
2. Remove the energy storage box (ESB) intermediate cover.




3. Remove the receptacle outlet cover screws (1).




4. Remove the 120-volt cable connector screws.
5. Disconnect the retainers securing the 120-volt cable to the ESB.




6. Note the routing of the 120-volt cable.




7. Remove the 120-volt cable (1) out through the receptacle opening (2) in the ESB.

INSTALLATION PROCEDURE




1. Feed the 120-volt cable (1) through the receptacle opening (2) in the ESB.




2. Route the 120-volt cable as noted earlier.




3. Connect the retainers securing the 120-volt cable within the ESB.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the 120-volt cable connector screws.

Tighten the screws to 6 N.m (53 lb in).




5. Install the receptacle outlet cover screws (1).

Tighten the screws to 0.5 N.m (4.4 lb in).

6. Install the ESB intermediate cover.




7. Connect the 120-volt AC electrical connector (3).