Coolant Pipe Quick Connect Fitting - Starter Generator Control Module

Coolant Pipe Quick Connect Fitting - Starter/Generator Control Module

Removal Procedure





1. Using a bent-tip screwdriver or equivalent, pull on one of the open ends of the retaining ring in order to rotate the retaining ring.
2. Rotate the retaining ring around the quick connector until the retaining ring is out of position and can be completely removed.
3. Remove the Starter/Generator Control Module (SGCM) radiator hose from the SGCM radiator.

Installation Procedure





1. Important: Do not install the retaining ring onto the fitting by pushing the retaining ring down over the fitting.

Hook one of the open ends of the retaining ring in one of the slots in the quick connector.





2. Rotate the retaining ring around the connector until the retaining ring is positioned with all 3 ears through the 3 slots.
3. Ensure the 3 retaining ring ears can be seen from the inside of the connector and the retaining ring can move freely in the slots.
4. Install the SGCM radiator hose to the SGCM radiator quick connector fitting until a click is heard or felt. Pull back on the SGCM radiator hose to ensure a proper connection.