Rear Wheel Steering

Steering Knuckle Replacement

^ Tools Required
- J 24319-B Universal Steering Linkage Puller

Removal Procedure

Notice: Refer to Rear Wheel Steering Lifting and Jacking Notice in Service Precautions.





1. Remove the upper ball joint.
2. Remove the lower ball joint.
3. Remove the wheel hub and bearing.
4. Remove the outer tie rod retaining nut (1).





5. Disconnect the outer tie rod from the steering knuckle using the J 24319-B (1).





6. Remove the park brake cable retaining bolt (3) from the steering knuckle.





7. Remove the steering knuckle (2) from the vehicle.

Installation Procedure





1. Install the steering knuckle (2) to the vehicle.
2. Install the upper ball joint.
3. Install the lower ball joint.





4. Notice: Refer to Fastener Notice in Service Precautions.

Install the park brake cable retaining bolt (3) to the steering knuckle.
^ Tighten the bolt to 65 Nm (48 ft. lbs.).
5. Install the wheel hub and bearing.





6. Install the outer tie rod retaining nut (1).
^ Tighten the nut to 55 Nm (40 ft. lbs.).
7. Install the tire and wheel.
8. Perform a four wheel alignment.