Harmonic Balancer - Crankshaft Pulley

Tighten the USED crankshaft balancer bolt 330 Nm (240 ft. lbs.)
Remove the used crankshaft balancer bolt.

Important: The nose of the crankshaft should be recessed 2.4 - 4.48 mm (0.094 - 0.176 inch) into the balancer bore.

Install a NEW crankshaft balancer bolt.
Tighten the bolt a first pass 50 Nm (37 ft. lbs.)
Tighten the bolt a second pass 140 degrees using J45059.