36. Stator Shaft Needle Bearing Replacement

Stator Shaft Needle Bearing Replacement

^ Tools Required
- J 26941 Oil Pump Cover Needle Bearing Remover
- J 8092 Universal Driver
- J 43775Oil Pump Cover Needle Bearing Installer





Important: Use this procedure if replacing only the stator shaft needle bearing.

1. Install J 26941 (1) into the bearing (2) so that the lips of the tool engage the bottom lip of the needle bearing race.
2. Tighten the screw of J 26941 finger tight.
3. Install a slide hammer onto the end of J 26941.
4. Remove the needle bearing (2).





Important: The needle bearing may be installed with either end up.

5. Install the large end of J 43775 (2) onto J 8092 (1).
6. Drive the needle bearing (3) into the oil pump cover assembly (4) until J 43775 sets.
7. Ensure the bearing is installed below the stator shaft surface.
The needle bearing installed depth measurement is flush to 0.25 mm (0.010 inch) below the stator shaft surface