Transmission Housing Oil Seal Replacement - Rear

Transmission Housing Oil Seal Replacement - Rear (2WD)
^ Tools Required
- J 8614-01 Pinion Flange Holder
- J 6125-1BSlide Hammer
- J 22834-A Rear Extension Housing Oil Seal Installer
- J 23129 Universal Seal Remover

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle.
2. Remove the rear propeller shaft.
3. If required, remove the following:
1. The main shaft nut
2. The prop shaft yoke washer
3. The main shaft washer
4. The yoke





4. Remove the rear seal using J 6125-B (1) and J 23129 (2).

Installation Procedure





1. Using J 22834-A install the NEW rear oil seal.





2. If required, install the following:
1. The yoke
2. A NEW main shaft washer
3. A NEW prop shaft yoke washer
4. The main shaft nut





3. If required, use J 8614-01 in order to keep the keep yoke from rotating.

Notice: Refer to Fastener Notice in Service Precautions.

4. Tighten the main shaft nut.
^ Tighten the nut to 441 Nm (325 ft. lbs.).
5. Install the rear propeller shaft.
6. Check the transmission fluid level. Add if necessary.
7. Lower the vehicle.