Radio Replacement

RADIO REPLACEMENT

REMOVAL PROCEDURE

1. Remove the cluster bezel.




2. Remove the 3 screws (1).
3. Pull out the radio assembly slightly in other to gain access to the connectors.
4. Disconnect the wire connectors.
5. Disconnect the coaxial cable from the radio.
6. Remove the radio assembly from the I/P.

INSTALLATION PROCEDURE




1. Connect the coaxial cable to the radio.
2. Connect the wire connectors.
3. Push in the radio assembly in the opening in order to install the screws.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the 3 screws (1).

Tighten
Tighten the screws to 1.6 N.m (14 lb in).

5. Install the cluster bezel.
6. Calibrate the new radio assembly. Programming and Relearning