Receiver Replacement - Digital Radio

RECEIVER REPLACEMENT - DIGITAL RADIO

REMOVAL PROCEDURE
1. Remove the right side junction block from the instrument panel (I/P).

IMPORTANT: Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock(R), and "XM Theftlock(R)" will display.

2. Lower the I/P compartment door to the full open position.
3. From the junction block opening, remove the 2 retaining screws.
4. Pull the receiver and bracket assembly from the I/P compartment opening.




5. Disconnect the wire connector (1).
6. Disconnect the coaxial cables from the receiver.
7. Remove the receiver and bracket assembly from the I/P.

INSTALLATION PROCEDURE




1. Connect the coaxial cables.
2. Connect the wire connector (1).
3. Install the receiver and bracket assembly to the I/P.
4. Install the 2 retaining screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 1.6 N.m (14 lb in).

5. Install the right side junction block to the I/P.
6. Close the I/P compartment door.
7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup.