131. Engine Flywheel Installation - Manual Trans

Engine Flywheel Installation (Manual Transmission)

Tools Required
^ J44643 Flywheel Hold Tool
^ J45059 Angle Meter





1. Install the pilot bearing.





2. Caution: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

Install the flywheel.

3. Notice: This component uses bolts with a preapplied molybdenum disulfide coating for thread lubrication. Do not remove the coating or use any additional lubricant. Improperly lubricated threads will adversely affect the bolt torque and clamp load. Improper bolt torque and clamp load can lead to engine damage.

Notice: Refer to Fastener Notice in Service Precautions.

Loosely install NEW flywheel bolts.





4. Install J44643 to hold the flywheel from rotating.





5. Use the following steps and the proper sequence to tighten the flywheel bolts:
1. Tighten the flywheel bolts to 79 Nm (59 lb ft).
2. Tighten the flywheel bolts to 60 degrees using the J45059.
3. Tighten the flywheel bolts again to 60 degrees using the J45059.

6. Remove J44643.