9. Rear Housing Assemble

Rear Housing Assemble

^ Tools Required
- J 25070 Heat Gun





1. Install the rear case shift shaft bushing.
2. If S/T vehicle, install the retaining ring for the shift shaft bushing.





3. If 4WD vehicle, install the main shaft rear bearing in the rear case.





4. Notice: Refer to Fastener Notice in Service Precautions.

If 4WD vehicle, install the main shaft bearing retainer and the bolts.
^ Tighten the main shaft bearing retainer bolts to 22 Nm (16 inch lbs.).





5. Using the J 25070 heat the rear housing countershaft bearing bore for 10 minutes.
6. Install the countershaft bearing race using a suitable bearing installer.