44. 1-2-3-4, 4-5 Clutch Housing Bushing Replacement

1-2-3-4, 4-5 Clutch Housing Bushing Replacement

^ Tools Required
- J 43778 1-2-3-4, 4-5 Clutch Bushing Installer
- J 8092 Universal Driver

Removal Procedure





Notice: DO NOT score the 1-2-3-4, 4-5 clutch housing bore when removing the clutch housing bushing.

1. Gently tap the bushing through the inside of the 1-2-3-4, 4-5 clutch housing until the bushing becomes dislodged.
2. Remove the bushing (2) from the 1-2-3-4, 4-5 clutch housing (1).
3. Remove any nicks or burrs with a crocus cloth.

Installation Procedure





1. Position the 1-2-3-4, 4-5 clutch housing (4) on a press so that the front of the housing is facing up.

Important: The preferred method for installing the 1-2-3-4, 4-5 clutch housing bushing is to use the J 43778 and a press. If a press is not available, use the J 43778 and the J 8092.

2. If the bushing will be installed without a press, install the large end of J 43778 (2) onto J 8092 (1).
3. Install a new bushing (3) onto J 43778 (2).
4. Using J 8092, press or drive the new bushing into the clutch housing.
The bushing depth measurement is flush to 0.25 mm (0.01 inch) below the 1-2-3-4, 4-5 clutch housing surface.