51. 4-5 Clutch Steel Plate Inspection

4-5 Clutch Steel Plate Inspection





Important:
^ Measure as described below at a minimum of 3 locations.
^ Replace any 4-5 clutch steel plate that does not meet specifications.

1. Measure the thickness of each 4-5 clutch steel plate (1) at dimension A.
The 4-5 clutch steel plate minimum thickness is 2.135 mm (0.0841 inch).





Important: Check the steel plates for coning on a level surface.

2. Measure the cone of each 4-5 clutch steel plate (1) at dimension A.
The 4-5 clutch steel plate maximum cone is 0.240 mm (0.0094 inch).