Spark Plug: Service and Repair

SPARK PLUG REPLACEMENT

REMOVAL PROCEDURE




1. Remove the spark plug wire.
2. Loosen the spark plug 1 or 2 turns.
3. Brush or using compressed air, blow away any dirt from around the spark plug.
4. Remove the spark plug. If removing more than one plug, place each plug in a tray marked with the corresponding cylinder.

INSTALLATION PROCEDURE




1. Correctly position the spark plug washer.
2. Inspect the spark plug gap. Adjust the gap as needed.

Spark plug gap: 1.524 mm (0.060 in)

3. Hand start the spark plug in the corresponding cylinder.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Tighten the spark plug.
- Tighten the plug to 20 N.m (15 lb ft) for USED heads.
- Tighten the plug to 30 N.m (22 lb ft) for NEW heads.

5. Install the spark plug wire.