Radio Replacement

RADIO REPLACEMENT

REMOVAL PROCEDURE
1. Remove the cluster bezel.




2. Remove the screws (1).
3. Pull out the radio assembly slightly in other to gain access to the connectors.
4. Disconnect the wire connectors.
5. Disconnect the coaxial cable from the radio.
6. Remove the radio assembly from the I/P.

INSTALLATION PROCEDURE




1. Connect the coaxial cable to the radio.
2. Connect the wire connectors.
3. Push in the radio assembly in the opening in order to install the screws.
4. Install the screws (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 1.6 N.m (14 lb in).

5. Install the cluster bezel.
6. Perform the radio setup , if equipped with UM8. Refer to Radio Setup (With RPO UM8).Refer to Service Programming System (SPS) in Programming for all other audio system configurations for setup. Programming and Relearning