Seat Back Cover and Pad Replacement - Rear (Bench)

SEAT BACK COVER AND PAD REPLACEMENT - REAR (BENCH)

REMOVAL PROCEDURE




1. Remove the seat from the vehicle.
2. Remove the headrests.
3. Remove the side trim plate and screws (1).




4. Remove the seat belt anchor bolt (1).




5. Remove the plastic seat belt guides (1).




6. Release the J-Clips from the trim.
7. Remove the plastic pushpin (1) from the side seat belt guide.
8. Remove the head restraint retainers.
9. Remove the seat back cover and pad from the frame.

INSTALLATION PROCEDURE




1. Install the seat back cover and pad to the frame.
2. Install the head restraint retainers.
3. Install the plastic pushpin (1) into the side seat belt guide.




4. Connect the J-clips to the trim.
5. Install the plastic seat belt guides (1).




6. Install the seat belt anchor bolt (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 53 N.m (39 lb ft).




7. Install the side trim plate and screws (1).

Tighten the screw to 2 N.m (18 lb in).

8. Install the headrests.
9. Install the seat to the vehicle.