Wiring Harness Replacement - Door (Cargo Door)

WIRING HARNESS REPLACEMENT - DOOR (CARGO DOOR)

REMOVAL PROCEDURE
1. Remove the trim panel.




2. Remove the wiring contact screws.
3. Disconnect the door wiring contact connector(s).
4. Disconnect the window defogger wiring connectors.
5. Disconnect the power door lock actuator connector (RHS only).
6. Disconnect the door ajar switch connectors.
7. Disconnect the key switch connector (RHS only).
8. Remove the wiring harness clips.
9. Remove the wiring harness from the door.

INSTALLATION PROCEDURE




1. Install the wiring harness to the door.
2. Connect the key switch connector (RHS only).
3. Connect the door ajar switch connectors.
4. Install the wiring harness clips.
5. Connect the power door lock actuator connector (RHS only).
6. Connect the window defogger wiring connectors.
7. Connect the door wiring contact connector(s).
8. Install the door wiring contact screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 2 N.m (18 lb in).

9. Install the trim panel.