Suspension: Service and Repair

Spring Bumper Replacement

Removal Procedure





1. Raise and support the vehicle.
2. Unsnap the jounce bumper from the mounting cup (4WD 15 Series).





3. Remove the nut from the jounce bumper stud (All 25/35 Series and RWD 15 Series with coil spring).
4. Remove the jounce bumper.

Installation Procedure





1. Snap the jounce bumper to the mounting cup (4WD 15 Series).





2. Install the jounce bumper (A1125/35 Series and RWD 15 Series with coil spring).

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the nut to the jounce bumper stud.
^ Tighten the nut to 30 Nm (22 ft. lbs.).
4. Remove the safety stands.
5. Lower the vehicle.