84. Throttle Body Assembly Installation

Throttle Body Installation





1. Notice: Refer to Fastener Notice in Service Precautions.

Install the throttle body studs, if required.
^ Tighten the throttle body studs to 6 Nm (53 lb in).

2. Important: DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.

Install the throttle body gasket (509) to the intake manifold.





3. Install the throttle body and nuts.
^ Tighten the throttle body nuts to 10 Nm (89 lb in).
4. Install the engine coolant air bleed hose and clamp to the throttle body.