Seat Replacement - Front Bucket

SEAT REPLACEMENT - FRONT BUCKET

REMOVAL PROCEDURE




1. Ensure that the seat is all the way rearward.

IMPORTANT: If removing both front power seats, remove the passenger seat first. Power to the passenger seat is terminated once the driver's seat is disconnected.

2. Remove the front bolts.
3. Ensure that the seat is all the way forward.
4. Remove the rear bolts.
5. Disconnect the seat electrical connectors to the body harness.
6. Remove the seat from the vehicle.

INSTALLATION PROCEDURE




1. Position the seat in the vehicle.
2. Connect the seat electrical connectors to the body harness.
3. Install the rear bolts.
4. Ensure that the seat is all the way rearward.

IMPORTANT: After installation of a manual seat, move your body around in the seat to insure that the manual seat adjuster positively locks into position.

5. Install the front bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the front seat mounting bolts to 52.5 N.m (39 lb ft).