Powertrain Control Module Programming and Setup

POWERTRAIN CONTROL MODULE PROGRAMMING AND SETUP

The following service procedures require either a programming or a setup event be performed for a complete repair.

Powertrain Control Module (PCM) Replacement
If the powertrain control module (PCM) is replaced, the following procedures must be performed:
1. The PCM reprogramming-Refer to Service Programming System (SPS).
2. The Crankshaft Position (CKP) Variation Learn-Refer to CKP System Variation Learn Procedure.

PCM Reprogramming
If the powertrain control module (PCM) needs to be reprogrammed, refer to Service Programming System (SPS).

Setup for Component Replacement
The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, a crankshaft position (CKP) variation learn procedure must be performed:
- Engine replacement
- Any engine repair that disturbs the crankshaft position CKP sensor or its relationship with the crankshaft reluctor wheel
- CKP sensor

Refer to CKP System Variation Learn Procedure.