4. Input Shaft Disassemble

Input Shaft Disassemble

^ Tools Required
- J 36513 Gear and Bearing Separator Plate





1. Important:
^ Only remove the bearings if replacing the bearings. Do not use the bearings again after removal.
^ You must also replace the race for the bearing being replaced.

Inspect the bearing for damage or wear. Refer to Bearings and Spacers Cleaning and Inspection.
2. Using a hydraulic press and the J 36513 (1), remove the input shaft bearing.





3. Remove the input shaft oil deflector using a suitable prying tool.
4. Discard the input shaft oil deflector after removal.