53. Forward Clutch Assembly Installation

Forward Clutch Assembly Installation

^ Tools Required
- J 36850 Transjel Lubricant
- J 38358-A Forward Clutch Assembly Remover/Installer





1. Align the direct clutch plates in order to aid in the installation of the forward clutch housing assembly (602).

2. Important: Following installation of the forward clutch housing assembly (602), the distance between the top of the speed sensor ring and the pump gasket surface should be approximately 98 - 99 mm (3.85 - 3.89 inch).

Using the J 38358-A, install the forward clutch housing assembly (602).
3. Install the overdrive carrier/forward clutch thrust bearing assembly (601) (silver side up) onto the forward clutch housing assembly (602). Retain with J 36850 or equivalent.