NVG 263-NP1 - Transfer Case

Transfer Case Shift Control Switch Indicator Always On - Two or More

Circuit Description
The indicator lamps circuit consist of 4 individual lamps contained inside the mode/range switch assembly. The following lamps are contained inside their respective range button:
^ 2HI
^ 4HI
^ 4LO
^ Neutral

When the ignition in ON, the transfer case shift control module illuminates the indicator that corresponds to the current transfer case gear position by providing a ground through a current limiting driver.

The transfer case shift control module flashes each indicator lamp after a shift has been requested, and continues to flash until the transfer case shift control module can complete the shift.

A solid state circuit located inside the switch supplies ignition voltage to the lamps. The solid state circuit also receives voltage when the headlamp switch is in the parklamp or headlamp position. When the solid state circuit receives voltage from the headlamp switch, the switch reduces the voltage supplied to the indicator lamps, dimming the lamps when the headlamps are ON.

Test Description

Step 1 - Step 6:

The numbers below refer to the step numbers on the diagnostic table.
2. This step tests the transfer case electrical control of the lamp circuits.
3. This step helps determine if there is a short to ground in the suspect indicator control circuits.