Door Lock and Side Window Switch Replacement - Driver Side

SWITCH REPLACEMENT - DOOR LOCK AND SIDE WINDOW - DRIVER

REMOVAL PROCEDURE




1. Remove the front door trim panel.
2. Disconnect the electrical connectors.
3. Remove the screw that retains the switch panel bezel (1) from the front door panel.




4. Remove the switch panel bezel from the door panel using a flat-bladed tool.




5. Using a wide plastic flat-bladed tool, release the retaining clips on both sides of the door module.
6. Remove the door module from the switch panel bezel.

INSTALLATION PROCEDURE




1. Install the door module into the switch panel bezel until it snaps into place.




2. Install the switch panel bezel and module to the door panel.




3. Install the screw that retains the switch panel bezel (1) to the front door panel.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 2 N.m (18 lb in).

4. Connect the electrical connectors.
5. Install the front door trim panel.
6. If equipped with camper mirrors program the door module. Refer to Service Programming System (SPS) in Programming.