Turbocharger Vane Position Control Solenoid Valve Replacement

TURBOCHARGER VANE POSITION CONTROL SOLENOID VALVE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the intake manifold cover.
2. Remove the turbocharger oil feed pipe banjo bolt and washer.
3. Reposition the oil feed pipe out of the way.




4. Disconnect the turbocharger vane control solenoid valve electrical connector.
5. Remove the vane control solenoid valve bracket bolt and bracket.
6. Remove the turbocharger vane control solenoid valve from the turbocharger.

INSTALLATION PROCEDURE




1. Install the turbocharger vane control solenoid valve to the turbocharger.
2. Install the vane control solenoid valve bracket and bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 23 N.m (17 lb ft).

3. Connect the turbocharger vane control solenoid valve electrical connector.




4. Position the oil feed pipe to the turbocharger.
5. Install a NEW turbocharger oil feed pipe washer and the banjo bolt.

Tighten the bolt to 34 N.m (25 lb ft).

6. Install the intake manifold cover.
7. Perform the turbocharger learn procedure. Refer to Turbocharger Learn Procedure.