Valve Clearance

Valve Clearance Adjustment





1. Remove the fan clutch.
2. Remove the upper valve rocker arm covers.
3. Rotate the crankshaft in order to bring the number 1 cylinder to top dead center (TDC) of the compression stroke. The number 1 cylinder is the front cylinder on the right bank. The mark on the crankshaft balancer should be aligned with the mark on the engine.





4. Loosen the valve adjusting screws.
5. Insert a feeler gauge between the tip of the rocker arm and the valve bridge.





6. Adjust the valve lash to 0.3 mm (0.012 inch). Refer to Valve Clearance Adjustment Specifications to determine which valves can be adjusted when the engine is at TDC.

Notice: Refer to Fastener Notice in Service Precautions.

7. Tighten the lock nut.
^ Tighten nut to 22 Nm (16 ft. lbs.).





8. Rotate the crankshaft one revolution in order to bring the number 1 cylinder to TDC of the exhaust stroke.





9. Loosen the valve adjusting screws.
10. Insert a feeler gage between the tip of the rocker arm and the valve bridge.





11. Adjust the valve clearance to 0.3 mm (0.0112 inch).
12. Tighten the lock nut.
^ Tighten nut to 22 Nm (16 ft. lbs.).
13. Install the upper valve rocker arm covers.
14. Install the fan clutch.

Valve Clearance Adjustment Specifications:

Valve Clearance Adjustment Specifications