Lubricant Level Inspection - Front Drive Axle

Lubricant Level Inspection - Front Drive Axle
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Make sure the vehicle is level.
3. Inspect the front axle for leaks. Repair as necessary.
4. Clean the area around the front axle fill plug.





5. Remove the front axle fill plug (1).
6. Inspect the oil level.
^ For the 8.25 inch axle, the oil level should be between 12 - 16 mm (0.50 - 0.625 inch) below the fill plug opening.
^ For the 9.25 inch axle, the oil level should be between 0 - 6 mm (0 - 0.25 inch) below the fill plug opening.
7. If the level is low, add oil until the level is between 12 - 16 mm (0.50 - 0.625 inch) for the 8.25 inch axle or 0 - 6 mm (0 - 0.25 inch) for the 9.25 inch axle. Use the correct fluid. Refer to Sealers, Adhesives, and Lubricants.

8. Install the fill plug.
^ Tighten the plug to 33 Nm (24 lb ft).

Notice: Refer to Fastener Notice in Service Precautions.

9. Lower the vehicle.