80. Water Crossover Installation

Water Crossover Installation





1. Install the thermostat (312) with the seal into the engine coolant crossover (308).
2. Install the water outlet (311).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the water outlet bolts (310).
^ Tighten the bolts to 30 Nm (22 ft. lbs.).





4. Install the gaskets and the engine coolant crossover.
5. Install the bolts.
^ Tighten the engine coolant crossover bolts to 50 Nm (37 ft. lbs.).





Important: Properly position the thermostat bypass hose clamps to avoid water pump pulley interference.

6. Install the thermostat bypass hose and clamps.





7. Install the drive belt tensioner.
8. Install the drive belt tensioner bolts.
^ Tighten the drive belt tensioner bolts to 50 Nm (37 ft. lbs.).