108. Rear Oil Seal Installation

Output Shaft Retaining Nut Installation - 4WD

^ Tools Required
- J 43769 Spanner Nut Wrench - 4WD





1. The fullest clockwise position of the manual shift shaft is Park (P), which engages the park pawl.
2. Using a wrench on the manual shift shaft flats (1), rotate the shaft to the fullest clockwise position.





3. Make sure the park pawl is engaged.
4. Install J 43769 (1) onto the output shaft retaining nut, 4WD (2).

5. Notice: Refer to Component Fastener Tightening Notice in Service Precautions.

Using J 43769 (1), install a new output shaft retaining nut, 4WD (2) onto the output shaft (3).
^ Tighten the nut to 61 Nm (45 ft. lbs.).





6. Important: The Neutral (N) position of the manual shift shaft is 2 detent positions counterclockwise from the fullest clockwise position.

Using a wrench on the manual shift shaft flats (1), rotate the shaft to the fullest clockwise position.
7. Rotate the manual shift shaft counterclockwise 2 detent positions.
8. Make sure the park pawl is disengaged.