2. Crankshaft Balancer Removal

Crankshaft Balancer Removal

^ Tools Required
- J 38416-B Harmonic Balancer Remover
- J 42846 Crankshaft Protector Button
- J 42847 Flywheel Holding Tool





Notice: Refer to Fastener Notice in Service Precautions.

Important: Ensure that the teeth of the flywheel holding tool engage the engine flywheel teeth.

1. Install the J 42847 (1) to the starter bolt holes.
^ Tighten the J 42847 bolts to 50 Nm (37 ft. lbs.).





2. Remove the crankshaft balancer bolt and washer.





3. Install the J 42846 onto the end of the crankshaft.





4. Install the J 38416-B (2) in order to remove the crankshaft balancer. Place the legs of the J 38416-B into the recesses cast into the backside of the balancer inner hub.
5. Tighten the center screw of the J 38416-B until the crankshaft balancer is removed from the end of the crankshaft.





6. Remove the J 38416-B.
7. Remove the crankshaft balancer.
8. Remove the J 42846 from the end of the crankshaft.





9. Remove the J 42847 (1).