Engine Control Module Programming and Setup

ENGINE CONTROL MODULE PROGRAMMING AND SETUP

The following service procedures require either a programming or a setup event performed for a complete repair.

ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
^ The ECM Reprogramming-Refer to Service Programming System (SPS).
^ The Turbocharger Learn Procedure-Refer to Turbocharger Learn Procedure.
^ Theft Deterrent-Refer to Programming Theft Deterrent System Components.
^ The Fuel Injector Flow Rate Programming-Refer to Fuel Injector Flow Rate Programming .
^ Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.
^ Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed.
^ Fuel Filter Life Remaining-When available, use a scan tool to reset the Fuel Filter Life Remaining back to the original percentage recorded before the module was reprogrammed.

ECM Reprogramming
If the engine control module (ECM) needs to be reprogrammed, refer to Service Programming System (SPS).

^ If the engine control module (ECM) needs to be reprogrammed, refer to Service Programming System (SPS) .
^ Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.
^ Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed.
^ Fuel Filter Life Remaining-When available, use a scan tool to reset the Fuel Filter Life Remaining back to the original percentage recorded before the module was reprogrammed.


Setup for Component Replacement
The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, a Turbocharger Learn Procedure must be performed.
- Turbocharger
- Turbocharger Vane Position Sensor.
- Turbocharger Vane Position Control Solenoid Valve