85. Low and Reverse Band Servo Assembly Installation

Low and Reverse Band Servo Assembly Installation





1. Install the low and reverse accumulator piston spring (74) into the transmission case.

2. Important: The low and reverse band servo assembly (64-73) is pushed down when tightening the cover bolts. Do not force the low and reverse band servo assembly (64-73) into the servo bore.

Install the low and reverse band servo assembly (64-73).





3. Install the low and reverse band servo cover gasket (63).
4. Install the low and reverse band servo cover (62).

5. Notice: Refer to Fastener Notice in Service Precautions.

Install the 6 low and reverse band servo cover bolts (61).
^ Tighten the bolts to 24 Nm (18 ft. lbs.) in an alternating pattern.