Vent Hose Connector Replacement - Front Drive Axle

Vent Hose Connector Replacement - Front Drive Axle
Removal Procedure
1. Raise the vehicle. Refer Lifting and Jacking the Vehicle in General Information.





2. Disconnect the vent hose from the vent hose connector.





3. Remove the vent hose connector from the differential carrier assembly.

Installation Procedure





1. Install the vent hose connector into the differential carrier assembly.Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent onto the threads.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Tighten the vent hose connector.
^ Tighten the vent hose connector to 28 Nm (21 lb ft).





3. Connect the vent hose to the vent hose connector.
4. Lower the vehicle.