Engine Mount Bracket Replacement - Right Side

Engine Mount Bracket Replacement - Right Side

Removal Procedure






Notice: Refer to Engine Mounting Notice.

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the engine mount to engine mount bracket bolts.






Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.

Important: Raise the engine only enough to permit removal of the engine mount bracket.

3. Using a jack on the square tab at the rear of the engine block and raise the engine, left side shown.




4. Remove the engine mount bracket mounting nuts.
5. Remove the engine mount bracket from the vehicle.

Installation Procedure




1. Install the engine mount bracket to the vehicle.

Notice: Refer to Fastener Notice.

2. Install the engine mount bracket retaining nuts.

Tighten the nuts to 45 N.m (33 lb ft).

3. Lower the engine.




4. Install the engine mount to the engine mount bracket bolts.

Tighten the bolts to 60 N.m (44 lb ft).

5. Lower the vehicle.