Turn Signal Flasher: Service and Repair

HAZARD AND TURN SIGNAL FLASHER REPLACEMENT

REMOVAL PROCEDURE




1. Remove the left knee bolster bracket.
2. Remove the turn/hazard flasher (2) from the instrument panel (I/P) support.
3. Disconnect the electrical connector (1).
4. Remove the turn/hazard flasher (2).

INSTALLATION PROCEDURE




1. Connect the electrical connector (1) to the turn/hazard flasher (2).
2. Install the turn/hazard flasher (2) to the instrument panel (I/P) support.
3. Install the left knee bolster bracket.