Crankshaft Position Sensor Replacement

Crankshaft Position Sensor Replacement

Removal Procedure

Important: Perform the CKP system variation learn procedure whenever the crankshaft position (CKP) sensor is removed or replaced. Refer to Crankshaft Position System Variation Learn.

1. Raise the vehicle. Refer to Vehicle Lifting.




2. Disconnect the CKP sensor harness connector.




3. Remove the CKP sensor mounting bolt.




4. Remove the CKP sensor.

Installation Procedure

Important: When installing the CKP sensor, make sure the sensor is fully seated before tightening the mounting bolt. A poorly seated CKP sensor may perform erratically and may set false DTCs.

Important: Do not use the original O-ring.

1. Replace the CKP sensor O-ring.
2. Lubricate the O-ring with clean engine oil before installing the CKP sensor.





Important: Make sure the CKP sensor mounting surface is clean and free of burrs.

3. Install the CKP sensor.





Notice: Refer to Fastener Notice.

4. Install the CKP sensor mounting bolt.

Tighten the mounting bolt to 8 N.m (71 lb in).




5. Connect the CKP sensor harness connector.
6. Lower the vehicle.
7. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn.