Maintenance II

MAINTENANCE II

1. CHANGE ENGINE OIL AND FILTER. Reset oil life system. Refer to Oil Change Reminder Lamp for information on the engine Oil Life System and resetting the system. An Emission Control Service.

2. LUBRICATE THE CHASSIS COMPONENTS. Lubricate the front suspension, steering linkage, transmission shift linkage, and parking brake cable guides. Control arm ball joints require lubrication but should not be lubricated unless their temperature is 10 degrees F (-12 degrees C) or higher, or they could be damaged. Vehicles used under severe commercial operating conditions require lubrication on a regular basis every 3,000 miles (5 000 km).

3. VISUALLY CHECK FOR ANY LEAKS OR DAMAGE. A fluid loss in any vehicle system could indicate a problem. Have the system inspected and repaired and the fluid level checked. Add fluid if needed.

4. INSPECT ENGINE AIR CLEANER FILTER. If necessary, replace filter. If you drive regularly under dusty conditions, inspect the filter, at each engine oil change.

5. ROTATE TIRES AND CHECK INFLATION PRESSURES AND WEAR.

6. INSPECT BRAKE SYSTEM. Visually inspect brake lines and hoses for proper hook-up, binding, leaks, cracks, chafing, etc. Inspect disc brake pads for wear and rotors for surface condition. Inspect other brake parts, including calipers, parking brake, etc.

7. CHECK ENGINE COOLANT AND WINDSHIELD WASHER FLUID LEVELS AND ADD FLUID AS NEEDED.

8. PERFORM ANY NEEDED ADDITIONAL SERVICES. Refer to Additional Required Services.

9. INSPECT SUSPENSION AND STEERING COMPONENTS. Visually inspect front and rear suspension and steering system for damaged, loose, or missing parts, signs of wear or lack of lubrication. Inspect power steering lines and hoses for proper hook-up, binding, leaks, cracks, chafing, etc. Pickup models: Visually check constant velocity joints, rubber boots, and axle seals for leaks.

10. INSPECT ENGINE COOLING SYSTEM. Visually inspect hoses and have them replaced if they are cracked, swollen or deteriorated. Inspect all pipes, fittings and clamps. To help ensure proper operation, a pressure test of the cooling system and pressure cap and cleaning the outside of the radiator and air conditioning condenser is recommended at least once a year.

11. INSPECT WIPER BLADES. Inspect wiper blades for wear, cracking, or contamination. Clean the windshield and wiper blades, if contaminated. Replace wiper blades that are worn or damaged.

12. INSPECT RESTRAINT SYSTEM COMPONENTS. Make sure the safety belt reminder light and all your belts, buckles, latch plates, retractors and anchorages are working properly. Look for any other loose or damaged safety belt system parts. If you see anything that might keep a safety belt system from doing its job, have it repaired. Have any torn or frayed safety belts replaced. Also look for any opened or broken air bag coverings, and have them repaired or replaced. The air bag system does not need regular maintenance.

13. LUBRICATE BODY COMPONENTS. Lubricate all key lock cylinders, hood latch assembly, secondary latch, pivots, spring anchor, release pawl, rear compartment hinges, outer liftgate handle pivot points, rear door detent link, roller mechanism, liftgate handle pivot points, latch bolt, fuel door hinge, cargo door hinge, locks and folding seat hardware. More frequent lubrication may be required when exposed to a corrosive environment. Applying silicone grease on weather-strips with a clean cloth will make them last longer, seal better and not stick or squeak.

14. CHECK TRANSMISSION FLUID LEVEL AND ADD FLUID AS NEEDED.

15. INSPECT SHIELDS, VEHICLES WITH GVWR ABOVE 10,000 LBS (4 536 KG) ONLY. Inspect shields for damage or looseness. Adjust or replace as required. This is a Noise Emission Control Service. Applicable to vehicles sold in the United States and recommended for vehicles sold in Canada.