Transfer Case Fluid Replacement

Transfer Case Fluid Replacement

Removal Procedure

Important:
When performing the following procedure, use only hand tools to remove and install the drain and fill plugs.





1. Remove the transfer case shield, if equipped. Refer to Transfer Case Fluid Replacement.
2. Remove the fill plug.





3. Remove the drain plug.

Installation Procedure

Notice:
Refer to Fastener Notice.

Important:
Use only drain and fill plugs that are made from aluminum. Steel or brass plugs are not compatible with the magnesium case.





1. Install the drain plug.

Tighten the plug to 20 Nm (15 ft. lbs.).

2. Fill the transfer case to the bottom of the fill plug hole with DEXRON III, GM P/N 12378470 (Canadian P/N 10952622).





3. Install the fill plug.

Tighten the plug to 20 Nm (15 ft. lbs.).

4. Lower the vehicle.