67. Oil Pump, Screen and Crankshaft Oil Deflector Installation

Oil Pump, Screen and Crankshaft Oil Deflector Installation





1. Install the crankshaft oil deflector.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the crankshaft oil deflector nuts.
Tighten the crankshaft oil deflector nuts to 50 Nm (37 ft. lbs.).





3. Important: During assembly, install a NEW oil pump driveshaft retainer. Slightly heat the retainer above room temperature for ease of installation onto the oil pump driveshaft.

Apply clean engine oil into the oil pump through the outlet oil hole. Rotate the pump in both directions in order to prime and lubricate the pump.
4. Assemble the oil pump, driveshaft, and a NEW retainer.
5. Install the oil pump assembly. Position the oil pump onto the locating pins.
6. Install the bolt attaching the oil pump to the rear crankshaft bearing cap.
Tighten the oil pump bolt to 75 Nm (56 ft. lbs.).
7. Pour clean engine oil into the oil pump pick-up screen.