NVG 261-NP2 - Transfer Case

Transfer Case Gear Indicator Switch Replacement

Removal Procedure





1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
2. Disconnect the gear indicator switch electrical connector (2).





3. Remove the gear indicator switch.

Installation Procedure





1. Notice:
Refer to Fastener Notice.

Install the gear indicator switch.

Tighten the switch to 27 Nm (20 ft. lbs.).





2. Connect the gear indicator switch electrical connector (2).
3. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.