Intake Air Temperature (IAT) Sensor 2 Replacement
INTAKE AIR TEMPERATURE (IAT) SENSOR 2 REPLACEMENT
REMOVAL PROCEDURE
1. Remove the air intake pipe.
2. Disconnect the intake air temperature (IAT) sensor electrical connector (1).
3. Remove the IAT sensor from the center intake manifold.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice.
1. Install the IAT sensor to the center intake manifold.
Tighten the IAT sensor to 25 N.m (18 lb ft).
2. Connect the IAT sensor electrical connector (1).
3. Install the air intake pipe.