Roof Marker Lamp Replacement (With RPO Code U01)

ROOF MARKER LAMP REPLACEMENT (WITH RPO CODE U01)

REMOVAL PROCEDURE




1. Remove the screws from the roof marker lamp lens.
2. Remove the roof marker lamp lens.
3. Disconnect the electrical connector from the roof marker lamp.
4. Remove the lamp assembly.

INSTALLATION PROCEDURE




1. Install the lamp assembly.
2. Connect the electrical connector to the roof marker lamp.
3. Install the roof marker lens.

4. NOTE: Refer to Fastener Notice.

Install the screws to the roof marker lamp lens.

Tighten screws to 1.9 N.m (17 lb ft).