NV 3500 - Manual Transmission

Vehicle Speed Sensor Replacement

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the vehicle speed sensor (VSS) electrical connector (1).





3. Remove the VSS and O-ring seal.

Installation Procedure





1. Coat a NEW O-ring seal with a thin film of Synchro-mesh transmission fluid GM P/N 12345349 (Canadian P/N 10953465), or equivalent.

Notice:
Refer to Fastener Notice.

2. Install the VSS and O-ring seal.

Tighten the VSS to 16 Nm (12 ft. lbs.).





3. Connect the VSS electrical connector (1).
4. Lower the vehicle.